0 with attribution required. Site design / logo © 2017 Stack Exchange Inc; user contributions licensed under cc by-sa 3.
Ovmctl –add ovm –name ,OVM_NAME, –ip ,OVM_IP, –netmask ,NET_MASK, –gateway ,DEFAULT_. Redhat Enterprise Linux 6. The following entities compose. 0+ Block Services Constructs. Default VM restart policy. For environments spanning multiple sites the OpenStack Controller will talk to multiple.
Use the command: mount -t vfat /dev/hda1 /mnt/C
Mount MS/windows partition with long filenames so Linux can look at it if Win95 is on your 1st partition on the first drive. Use option “-t umsdos” for DOS/Win 3. On my SCSI based system: mount -t umsdos /dev/sda3 /mnt/C) This requires that one create the directory mount point first (mkdir /mnt/C ) This mount can be made permanent by making the following entry to the /etc/fstab file:.
Multiple default gateways on the same interface. Is it valid to have multiple default gateways. In Red Hat, you can check the default gateway in /etc.
Of course you can add multiple default routes. Each over their own default gateway. Configure gateway for two NICs through static routeing.
debug1: Applying options for *
debug1: Reading configuration data /etc/ssh/ssh_config
debug1: Applying options for *
debug2: ssh_connect: needpriv 0
debug1: identity file /home/seeasown/. Ssh/id_dsa type -1
debug1: loaded 2 keys
ssh_exchange_identification: Connection closed by remote host
Couldn’t read packet: Connection reset by peer. 8e-fips-rhel5 01 Jul 2008
debug1: Reading configuration data /home/seeasown/. Ssh/id_rsa type -1
debug1: identity file /home/seeasown/.
Daily/tripwire-check to the /etc/cron. Tripwire is a great file system monitoring tool for a server but really un-necessary for a dial-up PPP system or a system which is rarely connected to the internet. The default is to use cron to run tripwire every day. This behavior can be changed to run tripwire weekly or monthly by moving the script /etc/cron. It is used to detect file changes by hackers.
1 and later) If the installation program presents itself as a text based console (DOS like) interface instead of a graphical based interface, chances are that the install program could not detect your graphics card and does not have the drivers for it. [Potential Pitfall]: (RH 6.
Static route configuration can be stored per-interface in a /etc/sysconfig/network- scripts/route-interface file. The route-interface file has two formats: ip command arguments and network/netmask directives. For example, static routes for the eth0 interface would be stored in the /etc/sysconfig/network-scripts/route-eth0 file.
Multiple NICs with Multiple Gateways on. Multiple NICs with Multiple Gateways on Centos;. With a new IP and different gateway from eth0.
Locally attached is explicitly defined as anything which is in any of the subnets on which you have an interface in the UP/RUNNING state and for which there is no explicit static route defined. 1 as Default Gateway – that is the default route for anything not locally attached.
Local) that will be executed once the network has been started after booting. For Debian, these command can also be written directly into the /etc/network/interfaces file, which would then appear as follows. The ip rule and ip route commands will become invalid after a re-boot, for which reason they should become part of a script (for example, /etc/rc.